Table of Contents
Advertisement
5. ASSEMBLY
a. Handle
Unscrew the handle.
-
On the main unit, locate the hole; Install the rubber tap by aligning the holes (the tap
-
is inside the handle).
Install first bottom of the handle, the pin must be inserted in the hole.
-
Install then the last part of the handle and screw it with the four screws.
-
Be sure that the handle is well oriented.
-
b. Tube on the main unit
Remove the rubber which is on the end of the tube.
-
On main unit, loosen the knob bolt (the tab should be pulled out).
-
Insert the tube in the tube engine
-
Tight a little the knob (not completely). Push the tab to close it.
-
Tight the knob bolt completely
-
c. Carter of protection (Brush cutter and grass trimmer)
On the tube of the brushcutter/grass trimmer, place the carter of protection on its
-
support.
Screw the carter of protection with the 4 screws.
-
NOTE: when using the brushcutter or the grass trimmer, the carter of
protection shall be always installed.
17
Advertisement
Table of Contents
