Table of Contents
Advertisement
9. DISPOSAL
Cutting remnants: do not throw with household rubbish or into the environment.
-
Dispose of cutting remnants in rubbish collection centers or seek advice from your
local municipality.
Tool: do not dispose with household garbage. Do not throw into the environment.
-
Remove oil and fuel from the machine, and dispose them in specific recycling centers.
-
Dispose of the product in a waste collection center; or seek advice from your local
-
municipality.
Proceed with disposal of remnants, tool, accessories, fuel mixture, oil and packaging
-
according to local regulations regarding the protection of the environment.
10. TROUBLESHOOTING
Problems
The tool cannot be
started
The tool starts but
no in a full power
The
engine
cannot reach its
maximal power
The
engine
generate of lot
of smoke
Causes
The starting process is not
followed
Spark plug dirty or moist
Incorrect carburettor
adjustment
Non-correct setting of the
starter
Air filter is dirty
Incorrect carburettor
adjustment
Non-correct gap between
the
electrode
and
spark plug
Incorrect carburettor
adjustment
Incorrect mix of the
tank
Incorrect
carburettor
adjustment
Resolutions
Follow the instructions of use of this
manual
Clean the spark plug or replace it by a
new one
Contact your dealer or contact SWAP
Open the starter
Clean the air filter
Contact your dealer or contact SWAP
Clean the spark plug and adjust the gap
the
between the electrodes or replace them
with a new one
Contact your dealer or contact SWAP
Do a correct mix of the fuel (see
the corresponding chapter)
Contact your dealer or contact SWAP
31
Advertisement
Table of Contents
