Appendix A: Error Codes - Laversab 6300-M3 User Manual

All errors are displayed on line 4 of the display when the 6300-M3 is in the Main screen.
An error must be acknowledged before any other key entries are accepted. The error may
be acknowledged either by pressing the CANCEL or the CLR key.
ERROR CODES
1 Pressure exceeded 110 %FS on Pt output
2 Pressure exceeded 110 %FS on Ps output
3 Pt target value exceeds Qc limits
4 Pt target value exceeds Mach limit
5 Ps rate target exceeds Rate limit
6 Ps target exceeds altitude limits
7 Pt actual value exceeds Qc limit
8 Pt actual value exceeds Mach limit
9 Rate exceeds limits.
10 Unused
11 Invalid Profile point
12 Ps control-transducer error
13 Pt control-transducer error
14 Ps actual value exceeds limit
15 Internal Use only
16 Internal Use only
17 If Pt is left in Measure mode, Qc limit will soon be exceeded
18 If Pt is left in Measure mode, Mach limit will soon be exceeded
19 Loss of Actual data
APPENDIX A
ERROR CODES
DESCRIPTION
62