Profiles; What Is A Profile - Laversab 6300-M3 User Manual

Profiles are created in Microsoft Excel and downloaded into the 6300-M3 through the
COM1 port on your PC using the Hyperterminal program that is normally available on all
PC's.

4.1 WHAT IS A PROFILE.

A profile is a set of up to 50 points that tell the 6300-M3 what you would want it to do at
each point. Each point consists of 7 parameters: 1) Pitot units, 2) Pitot mode, 3) Pitot target
value, 4) Static units, 5) Static mode, 6) Static target value and 7) Static rate (Climb) target
value. These 7 parameters are defined by you in the Excel program.
A total of 20 such profiles can reside in the 6300-M3 at any time. Each profile is identified
by a number between 1 to 20 and also a name which can have up to 12 characters. The
profile number and the name are also part of the profile that is created in Excel.
A typical profile named "Sample" is shown below as it would appear in Excel.
A B
1
2 Sample
3 knots Control
4 knots Control
5 knots Leak
6 knots Control
7 knots Control
8 knots Control
9 knots Control
10 knots Control
11 knots Control
12 knots Control
13 knots Control
14 knots Measure
15 END
Row 1 always says "Profile". This indicates to the 6300-M3 that a profile is to follow.
Row 2 left cell shows the name of the profile. This profile is named "Sample". The name
can have up to 12 alphanumeric characters. This name will show up on the 4
SECTION 4

PROFILES

C D E
Profile
3
100.0 Feet Control
200.0 Feet Control
200.0 Feet Control
100.0 Feet Control
200.0 Feet Control
300.0 Feet Control
100.0 Feet Control
100.0 Feet Leak
100.0 Feet Control
100.0 Feet Control
20.0 Feet Control
20.0 Feet Measure
41
F G
0
0 6000
0 6000
0 6000
1000 6000
5000 6000
10000 6000
18000 6000
18000 6000
30000 6000
50000 6000
Ground 6000
Ground 6000
th line of the