Laversab 6300-M3 User Manual page 35

While in the Static Leak Screen, if the leak ever exceeds 2000 ft/min, the 6300-M3 will
automatically trip out of the Leak mode and revert back to Control mode. It will then display
a message as follows:
While in the Pitot Leak Screen, if the leak ever exceeds 50 knots/min, the 6300-M3 will
automatically trip out of the Leak mode and revert back to Control mode. It will then display
a message as follows:
When either of these warning messages is displayed, press GO, which will bring up the Main
Operating Screen. At this point it is recommended to go back to GROUND and to Measure
mode on both outputs ad fix the leak before proceeding further.
It is important that each output be put into the Leak mode independently. That is, when
the Pitot system of the aircraft needs to be checked for leaks, only the Pitot output should
be in Leak mode, keeping the Static output in Control mode. When the Static system of the
aircraft needs to be checked for leaks, only the Static output should be in Leak mode,
keeping the Pitot output in Control mode.
Pressing the CANCEL key allows you to exit from the Leak Screen, back to the Main
Operating Screen. If the mode prior to entering the Leak mode was Control then the 6300-M3
will revert back to Control mode on exiting the Leak Screen.
3.3.1 TIMED-LEAK SCREEN
Static leak exceeds 2000 ft/min.
Returning STATIC to Control Mode.
Please press "GO"
Pitot leak exceeds 50 knots/min.
Returning PITOT to Control Mode.
Please press "GO"
28