Table of Contents
Advertisement
NEW RATE =
min : 50 ,
The knots rate is the rate at which the Actual airspeed value is ramped towards the Target
airspeed value. A typical knots rate value of 500.0 is ideal for most operations. Enter the
desired value followed by the ENTER key. This will take you into the following screen which
shows that a new value of 300.0 was entered. Press GO to return to the Main screen.
Thank you.
NEW RATE = 300.0
3.5.4 FUNCTION 4: VIEW & EXECUTE PROFILES
To execute a profile, press Function Select and then press "4". This will bring you back into
the Main Screen as shown below. You will need to enter the profile number that you want to
execute. A full explanation of profiles is given in Section 4.
Units:
Actual:
Target:
ENTER PROFILE NUMBER :
Assuming you enter a profile number of "2.1", followed by the ENTER key, the first point of
profile # 2 will be displayed on the screen. Also, the name of the profile is shown here. This is
shown in the screen below. The name of profile 2 is CJ1-RVSM. In this profile note that both
Modes changed to "C", and all three target values changed.
programmed as the first point of profile # 2. You will also notice that the number "2.1" is
flashing. This indicates that the current profile point is ready for execution and awaiting the
"GO" key to be pressed. When the "GO" key is pressed, the 6300-M3 will execute the profile
point, i.e. it will change to Control mode and move towards the desired targets.
Units:
Actual:
Target:
ENTER PROFILE NUMBER :
Once the targets have been achieved, you can move to the next profile point by pressing
ENTER. Then, the parameter values in point 2 of profile # 2 will be displayed, the profile
knots /min.
max : 500
Press "GO" to continue.
knots /min.
knots
M
101.2
20.0
knots
C
101.2
100.0
2.1 CJ1-RVSM
37
Feet/min
Feet
3500
1005
3000
.
Feet/min
Feet
3500
1005
5000
1000
M
0
These parameters were
C
Advertisement
Table of Contents
