Table of Contents
Advertisement
[5]
DC Fuse :
A 5x20 mm fuse is located inside the fuse holder. The fuse is a time-delay fuse with a rating of
15 amps, 250 Volts.
[6]
DC On / Off Switch :
This toggle switch is used to connect (or disconnect) DC power between the DC INPUT
connector and the 6300-M3.
Note:
When this switch is in the ON position, the unit becomes fully operational only
after the "READY" LED is ON and the On/Off switch on the Remote Unit is ON.
[7]
Remote Unit connection:
The 6300-M3 is provided with a 50 foot remote cable to connect to the Remote unit. The male
end of the remote cable is connected here on the top panel. The female end of the remote cable
is connected to the Remote unit. This cable should be connected prior to applying power to
the 6300-M3. This cable should not be disconnected while power is applied to the 6300-M3.
The remote cable is normally left connected to the 6300-M3 at the "Remote" connector on the
top panel and is wrapped around four cord posts on the lid of the 6300-M3 case. The cord
retainers on top of these posts swivel in either direction and latch at 180 degree positions,
allowing easy wrapping and unwrapping of the remote cable. A cord clamp allows the cable
to be held in place after it is wrapped. It is easier to wrap the remote cable around the posts
after disconnecting the cable from the Remote unit.
If the remote cable needs to be disconnected and removed from the 6300-M3 completely for
storage elsewhere then opening the Interface Connectors cover allows the cable to be
dislodged from the cable guide.
[8]
Static ports :
The Static output is provided on two ports that are internally connected. Both ports have #6-
AN (or #4-AN) fittings. At least one of these ports must be connected through a hose to the
Static port on the aircraft. The hose must be connected after performing the Self Test on the
6300-M3. The hose, once connected, must not be disconnected while the aircraft Static system
is not at "Ground" level. An unused port must remain closed.
Caution:
Do not connect the Static hose to the Static port before performing the Self
Test.
Caution:
Do not disconnect the Static hose from the Static port unless the aircraft Static
5
Advertisement
Table of Contents
