DEEP SEA ELECTRONICS DSE8610 MKII Operator's Manual page 103

NOTE: For further details, see section entitled Operation elsewhere in this manual.
Icon Description
Alarm Mute / Lamp Test
This button silences the audible alarm in the controller, de-activates the Audible
Alarm output (if configured) and illuminates all of the LEDs on the module's facia
as a lamp test function.
Start
This button is only active in the Stop/Reset Mode
Pressing the Start
ECU but does not start the engine. This can be used to check the status of the
CAN communication and to prime the fuel system.
Pressing the Start
it off load in Manual Mode
Menu Navigation
Used for navigating the instrumentation, event log and configuration screens.
Close Generator
The Close Generator
switch and is only active in the Manual Mode
available.
Pressing the Close Generator
off load automatically instructs the generator to synchronise and once in sync, to
be place the generator on load ('Close Generator Output' becomes active). If
the generator bus is dead (has not supply on it) the generator is placed on load
immediately. Further presses of the Close Generator
Open Generator
The Open Generator
allows the operator to open the generator load switch.
Pressing the Open Generator
automatically ramps the load off the generator and then takes it off load ('Close
Generator Output' becomes inactive). Further presses of the
Open Generator
Description of Controls
button in Stop/Reset Mode
button in Manual Mode
button controls the operation of the generator load
button when the generator is available and
button is only active in the Manual Mode
button when the Generator is on load,
button have no effect.
Page 103 of 246
, Manual Mode
powers up the engine's
starts the generator and runs
once the generator is
button have no effect.
and
057-254 ISSUE: 10