Table of Contents
Advertisement
C C h h a a p p t t e e r r 4 4 I I n n t t e e r r f f a a c c e e s s a a n n d d C C o o m m m m u u n n i i c c a a t t i i o o n n
4 4 . . 1 1
C C o o n n t t r r o o l l p p a a n n e e l l
The screen provides useful information about the UPS itself, load status, events, measurements and settings.
Table 14. Control Panel Details
The following table shows the indicator status and description :
Table 15. LED Indicator Details
Indicator
Green
Orange
Red
4 4 . . 2 2
L L C C D D D D e e s s c c r r i i p p t t i i o o n n
The LCD screen has 2 lines, each line may show 16 characters maximum. The first line shows UPS mode,
which may be standby mode, normal mode, battery mode, backup end mode or fault mode. The second line
shows measures. The backlight LCD automatically dims after 5 minutes of inactivity. Press any button to
restore the screen.
NORMAL MODE
LOAD:35% 1050W
Status
On
On
Flashing
On
1.
Power ON indicator (green)
2.
On battery indicator (orange)
3.
Alarm Indicator (red)
4.
Escape
5.
Up
6.
Down
7.
Enter
8.
On/Off button
Tripp Lite by Eaton SmartPro Advanced User Guide 614-40194—Rev 01
Description
The UPS is "On" and the load is
protected.
The UPS is in battery mode and the load
is protected.
The battery voltage is below the warning
level.
The UPS has an active alarm or fault. See
troubleshooting page for additional
information.
19
Advertisement
Table of Contents
