Operating Modes; Normal Mode - Eaton BladeUPS User Manual

Table 13. User Settings (Continued)
Description
User Password
Audible Alarms
Unsynchronized Transfer to
Bypass
Transfer to Bypass When
Overload
Automatic Start Delay
Control Commands from X-
Slot1
Control Commands from X-
Slot2/Serv
X-Slot Signal Input Activation
Delay
Site Wiring Fault Notice
Input Range
Reset Custom Event Settings
REPO Configuration
SEE NOTE Delayed Rectifier
Startup Settings
NOTE Delayed rectifier startup increases existing delays for utility outages. This will allow a maximum of 50 seconds of
additional delay before starting the Rectifier and thus transferring the load to the rectifier feed.
When the group number is changed, the delay is determined by (Group #) * (Delay Value) = Delay in seconds. An RT unit
would return the load to utility after the delay. After the delay, a parallel unit would have the lowest unit ID return to
utility and subsequent units would return using a brief delay. The group and delay settings will be synchronized across all
parallel units
When the group number is changed, the delay is determined by (Group #) * (Delay Value) = Delay in seconds. An RT unit
would return the load to utility after the delay. After the delay, a parallel unit would have the lowest unit ID return to
utility and subsequent units would return using a brief delay. The group and delay settings will be synchronized across all
parallel units
5 5 . . 6 6 O O p p e e r r a a t t i i n n g g M M o o d d e e s s

Normal Mode

Available Settings
[Enabled] [Disabled]
If Enabled is selected, the password is USER.
[Normal Sound] [Disabled]
[Allowed] [Not Allowed]
[After a delay] [Immediately]
-1 through 32767 seconds
(-1 means disabled)
[Allowed] [Disabled]
Selecting Disabled prevents load commands such as Load
Off through the X-Slot, including remotely.
0 through 65 seconds
[Enabled] [Disabled]
[Standard] [ITIC}
0 through 32
[Enabled][Disabled]
Group number: 0 through 10 (integers only);
Delay in seconds: 2 through 5 sec (integers only)
Eaton BladeUPS 5 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 14

Operating Modes

Default Setting
Disabled
Normal Sound
Not Allowed
After a delay
0s
Allowed
5s
Alarm Enabled
Standard
Total: 0/32
Enabled
0 (Zero disables this feature)
5
99