Common Function Quick Setting Instruction - ForceDoor BASE70 Instructions And User Manual

COMMON FUNCTION QUICK SETTING INSTRUCTION

Function Operation
Item
AUTO CLOSE Short press：
Force Short press：
Adjustment
Long press
Running the button for 6 seconds：
Cycle
Counter
Inquiry
Long press
Restore the button for 10 seconds：
Factory
Setting
Description
Important:
The "AUTO CLOSE" only can be activated when the Photo
beam or light curtain has been correctly installed and the
photo beam function has been enabled from function menu
(Refer to page 17-18 - Menu 5).
 Short press the "AUTO CLOSE" button, when the
indicator light is turned on. It means the "AUTO
CLOSE" function has been activated.
(Default: The door only can auto close while in the open
limit position. And the Auto Close time is 15 seconds).
Refer to page 16 - Menu 4 to change any setting for AUTO
CLOSE conditions or time if necessary.
Note: If there is no any photo beam or light curtain
installed, the door can not be closed, and the LED display
will show the letter "E6" as an indication.
 Short press the "AUTO CLOSE" button, when the
indicator light is turned off. It means the "AUTO
CLOSE" function has been dis-activated.
 Short press the button, the digital display will indicate
the current force level firstly
 Continually short press the button: Incremental rolling
display the force level between
L1: Minimum force level ；
L9: Maximum force level
Note: L3 to L7 is recommended.
 The digital will rolling display
been 10 running cycles worked.
Note: The running cycles is displayed in 6 digits
 The digital will rolling display
，then release the button, it means the
drive has been restored to factory setting.
Note: The running cycle counter record will not been
cleared.
5
to
, it represents the drive has