ForceDoor BASE70 Instructions And User Manual page 24

PB2 Port function setting (NO)

Press SET enter into the PB1 Port
function setting.
Execute OPEN-STOP-CLOSE the
door action.Single-cycle function

Execute CLOSE the door action
ONLY at the open limit position.

Execute OPEN the door action ONLY
at the close limit position.

Door
executed at any position other than
the close/open limit position
Execute ONLY OPEN the door
action. No matter where the motor is and
what state is triggered, the motor will
perform ONLY OPEN action (Including
radar, infrared sensors trigger)
Execute PARTIAL OPEN the door
function. Refer to
Execute Community function.
(default) Means:

Execute ONLY OPEN the door action
during the door closing process

But during the door opening process,
it will not execute OPEN the door
action, even though the motor is
triggered
Remark：
Execute Community function.
(default)

Press and hold SET button for about
6 seconds to enter main menu until
"0.-" appears on the display then
release the button.
 Press "+" till "6.-" appears on the
display.

Press SET then appears "6.0" on the
display
22
opening action will be