ForceDoor BASE70 Instructions And User Manual page 32

MENU8
Maintenance alarm
cycle-counting setting
minutes. Select the delay time of the
courtesy light, press the SET button to save
setting,At the same time, enter the warning
function setting of the courtesy light ，
digital tube display
from
warning function is off.
warning 1-9 second time selection,1-9
second option means flashing before door
drive starts running.
Remark： a. After the door drive stops running, the
b. After the courtesy light warning
Maintenance Alarm Function Setting



30
， Adjust the stalls
to by buttons +/-.
means the courtesy light operation
to means:The corresponding
courtesy light delay time can be
adjusted from 1 ～ 9 minutes, the
default is ，means 3 minutes off
delay.
function is turned on, the courtesy light
will flash for a corresponding time
before the door drive runs each time,
and then the door drive will start to
perform actions.
Press and hold SET button for about
6 seconds to enter main menu until
"0.-" appears on the display then
release the button.
Press "+" till "8.-" appears on the
display.Press SET then " 8.0 "
appears on the display.
Press SET to enter the Maintenance
alarm cycle-counting setting.
Indicates that the maintenance