Table of Contents
Advertisement
Setting the Anti-kick back guide
Place your work on top of the work table and lower the
anti-kick back guide by loosening the drop foot clamping knob.
Position the anti-kick back guide, so its just above your work
piece, clamp the drop foot assembly in position, see fig 10-11.
Fig 10-11
NOTE: If you are new to scroll saws, there will be a learning
period, a period to learn the saw itself, and a period to learn
how the wood and saw work together.
Expect some blade breakages, scroll saw blades are fairly
fragile, compared to blades found on a bandsaw.
UNDER NO CIRCUMSTANCES SHOULD
CHILDREN BE ALLOWED IN THE WORK AREA
AND KEEP TOOLS AND EQUIPMENT OUT OF
REACH OF YOUNG CHILDREN!
CHECK THAT EVERYTHING IS SECURE, THAT
THE BLADE IS TIGHT AND ALL NON ESSENTIAL
ITEMS HAVE BEEN CLEARED AWAY FROM THE
WORK AREA. CONNECT A DUST EXTRACTION
UNIT TO THE DUST EXTRACTION OUTLET ON
THE SCROLL SAW.
SETUP AND ADJUSTMENT
Setting the Air Blower Nozzle
Loosen the screw (A) holding the air blower nozzle and adjust
so its pointing towards the front of the blade, see fig 12-13.
A
OPERATING INSTRUCTIONS
SEE THE SYMBOLS ON PAGE TWO FOR
WEARING THE CORRECT SAFETY PROTECTION
WHEN USING THIS MACHINE.
CONNECT A DUST EXTRACTION
MACHINE TO THE SAW.
CONNECT THE SCROLL SAW TO THE MAINS
SUPPLY AND SWITCH ON.
1. Before turning on the scroll saw make sure the variable speed
control is turned down low, see fig 14. Place the work piece on
the table and lower the guard so its just above the work piece.
11
Fig 12-13
Continues over...
Advertisement
Table of Contents
