Table of Contents
Advertisement
PROBLEM
Breaking Blades
Motor will Not Run
Excessive Vibration
(Some vibration is inevitable when
the saw and motor are running)
PROBABLE CAUSES
1. Incorrect tension.
2. Overworked (worn out) blade.
3. Wrong blade being used.
4. Twisting blade in wood.
1. Defective cord,plug or outlet
2. Defective motor.
1. Improper mounting of saw.
2. Unsuitable mounting surface.
3. Loose table.
4. Motor mount is loose
19
TROUBLESHOOTING
SUGGESTED REMEDY
1 Adjust blade tension.
2. Reduce feed rate or replace blade.
3. Use narrow blades for thin wood,
wider blades for thicker wood.
4. Avoid side pressure on blade.
1. Unplug saw, replace defective parts.
2. Repairs MUST be made by a qualified
technician. Call Axminster Tool Centre.
(Technical Sales Phone: 0800 371822).
1. See proper mounting instructions.
2. Replace plywood workbench
surface with solid lumber surface.
3.Tighten table clamping knob.
4. Tighten motor mount screws.
Advertisement
Table of Contents
