Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Fig 14-15
2. Switch on the scroll saw by pressing the 'GREEN ON' button,
see fig 15. Adjust variable speed so its a between 'Low and High' ,
supporting the work piece with both hands slowly guide the
work piece forward into the blade, see fig 16.
Fig 16
NOTE: You must guide the wood into the blade SLOWLY,
because the teeth are very small, and it cuts ONLY on the
downward stroke. If you push the wood into the blade too
rapidly, you can easily break the blade.
NOTE: If you find the blade is struggling to cut through,
increase the speed by turning the variable speed knob.
3. Once you have completed your cut, switch off the scroll saw
by pressing the red 'OFF' button.
DISCONNECT THE SCROLL SAW
FROM THE MAINS SUPPLY!
4. If you have finished using the scroll saw, clean above and
below the work table and wipe the scroll saw over, see fig 17.
5. If the scroll saw is not going to be used for
a period of time, use 'Ambersil Dry PTFE Film
Antistick' , spray, code 952137 over the work
table to prevent the table from rusting and
place a dust sheet over the scroll saw.
Tilting the table to 45˚
1. Loosen the table's butterfly clamp and rotate the table to
+ /- 45˚ degrees and re-tighten clamp, see fig 18-19.
12
Fig 17
Fig 18-19
Advertisement
Table of Contents
