Advertisement
IARMOR EDGE™
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS
ARE PRESENT. READ INSTRUCTIONS CAREFULLY
BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED. THANK YOU FOR CHOOSING OUR
PRODUCT!
*ROCKER PANEL MOUNT
*DRILLING MAYBE REQUIRED
Driver
1#
1#
1#
iArmor
Front
4#
4#
4#
Customer Support: info@iarmorauto.com
®
Fastener Size
Tightening Torque (ft-lbs)
6mm
8mm
10mm
12mm
14mm
3#
3#
3#
1
PART#: IA-W208
Required
√
6-7
16-18
√
31-32
√
56-58
X
92-94
X
Passenger
2#
2#
2#
Rev. 20220501
Advertisement
Table of Contents
Related Manuals for iArmor EDGE IA-W208
Summary of Contents for iArmor EDGE IA-W208
- Page 1 ® IARMOR EDGE™ PART#: IA-W208 Fastener Size Tightening Torque (ft-lbs) Required BEFORE INSTALLATION REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS √ ARE PRESENT. READ INSTRUCTIONS CAREFULLY 16-18 √ BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. THANK YOU FOR CHOOSING OUR...
- Page 2 ® Hardware Package A (For Brackets & Step Bars Installation) Item Description Item Description Driver Side Mounting Brackets M8X1.25 Hex Nuts Passenger Side Mounting Brackets M8X1.25 Nylon Lock Nuts M6X1-25 Hex Bolts Passenger Side Support Brackets Driver Side Support Brackets...
- Page 3 ® The instruction here is for your reference only. We strongly the Bolt Plate from falling into the body panel within recommend the professional installer for best result. We are not bracket installation. responsible for any damage caused by the installation.
- Page 4 ® Factory Threaded In- serts on Body Panel M8 Plastic Washer Front (Fig 5) Thread Plastic Washer onto Bolt Plate to hold Bolt (Fig 7) Passenger Side Front Mounting Location Plate in position (Example for models with factory threaded inserts) (2) M8X1.25-30 Hex Bolts...
- Page 5 ® IMPORTANT: Some trims are without factory holes on pinch weld and will require drilling through the pinch weld to attach the Support Bracket. Do not drill on pinch weld at this moment, (Refer to STEP 6). Front Passenger Side...
- Page 6 ® STEP 7 b. Line up the slots on the Support Brackets with the back of the pinch weld. Mark the location of the slots onto the pinch weld. Move to the other side of the vehicle. Repeat Steps 1-6 to in- c.
Need help?
Do you have a question about the EDGE IA-W208 and is the answer not in the manual?
Questions and answers