Table of Contents
Advertisement
1" Adjustable trim kit
Fireplace Facing
When sizing the finish material for your fireplace, it is important to
remember the following: THE OPENING MUST NOT BE OBSTRUCTED IN
ANY WAY - to do so restricts the air supply for the control compartments
and it also prevents access for servicing controls.
1
The facing material should be fully finished before
installation of the trim kit.
2
Slide the side pieces into the top and bottom tracks.
XG0232 - 043021
3
Ensure the all 4 corners of the trim kit are squared
off. Before installation orient the trim so the notched
section is on the bottom.
Corners squared off
4
The Trim slides on the inside of the flush frame of the
opening. Push in until the trim is flush with the facing
material.
The trim can slide in and out to the full depth of the
5
facing material providing it falls within the depth
limits of the trim kit. A construction adhesive can be
used to better secure the trim.
Installation
Notch
on the
bottom
31
Advertisement
Table of Contents
