Environmental Conditions; Handling; Packing Instructions - MAGSTIM BiStim2 Operating Manual

6.3

Environmental Conditions

Operating temperature:
Transport and storage temperature:
Operating, transport and storage relative humidity:
Operating atmospheric pressure:
Transport and storage atmospheric pressure:
6.4

Handling

The master and slave units weigh in excess of 20kg. If it is necessary to move the units for any
reason, the weight must be distributed between at least two persons. Please see diagram below for
recommended manual handling methods. The master and slave units should be moved individually.
Note: The weight of Magstim Bistim² unit is unevenly distributed with the right hand side of the unit
being considerably heavier than the left. Care should be taken when transporting the unit to ensure
that this heavier side is adequately supported.
6.5

Packing Instructions

If, for any reason, it is necessary to return your Magstim Bistim² care should be taken to ensure that
the equipment is adequately packed to prevent transit damage. Ideally the equipment should be
returned in its original packing. If this or an adequate replacement is not available, replacement
shipping cartons can be obtained from the Magstim Company Limited.
The Magstim Bistim² System must be completely disconnected before shipping, including removal of
the coil holder and Bistim² Connecting Module on the side of the master unit. Failure to do so is likely
to result in transit damage to the casing.
© The Magstim Company Limited
*
Figure 6.1: Guidelines on lifting and lowering
21
5°C to 40°C
-19°C to 60°C
10% to 80% (non-condensing)
80kPa to 106kPa
50kPa to 106kPa
Magstim BiStim²
Operating Manual
MOP02-EN-02