Table of Contents
Advertisement
R
K. Thermostat Installation
1
A 12 volt AC thermostat is required to operate this pellet
.
appliance. You may use the included wall mount thermo-
stat or purchase an optional programmable thermostat
or remote control.
The included thermostat is equipped with an adjustable
heat anticipator. The current rating is .05 amps. The
anticipator needs to be adjusted to the lowest setting
available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted on
an inside wall and not in direct line with the appliance
convection air. Remove any packaging from inside
the thermostat before using.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
Fuse
Heat Output
Switch
Reset Button
Figure 38.1
October 27, 2011
Control Box
Red Call
Light
Thermostat
Block
Junction Box
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appli-
ance.
The 230 outlet on the junction box is for a remote
control ONLY. Do not use outlet for any other
purpose. It can damage the appliance and it will
void your warranty.
Power Cord
Outlet
7069-101B
Castile & Santa Fe CE Insert
CAUTION
CAUTION
Page 35
Advertisement
Table of Contents
