E008-0002 / E008-0003: Fixing Belt Unit Life Detection Error; E007-0101: Fixing Belt Home Position Detection Error - Canon imagePRESS C800 Series Technical Workbook

T E C H N I C A L W O R K B O O K
* The Current Value refers to the figure at the left end. The figures are displayed in the order of "Maximum
Value", "Present Value", "Maximum Value before Replacement" and "Final Value after Replacement". A typical
Current Value for FX-MTR5 under load should be ≤ 90 (0.9A).
1-a) When the Current Value is ≤ 90 (though the pressure is released and the load onto the Pressure Belt
Unit is small), inspect the three (3) subsequent elements:
a-1. Inspect the life of the Pressure Belt Unit and if it is reaching its life, replace the Pressure Belt Unit.
a-2. Inspect the Fixing Units Drive System Gear and if any abnormality such as breakage is found,
replace the Gear.
a-3. Inspect the Fixing Motor (M48) and if any abnormality is found, replace the Fixing Motor.
1-b) When the Current Value is ≥90 (though the pressure is released, the load onto the Pressure Belt Unit
is large), inspect the subsequent three elements:
b-1. Inspect the Fixing Units Drive System Gear and if any abnormality such as breakage is found,
replace the Gear.
b-2. Inspect the Fixing Motor (M48) and if any abnormality is found, replace the Fixing Motor.
b-3. Inspect the Relay PCB and if any abnormality is found, replace the Relay PCB.
2) After any of the aforementioned remedies, navigate to Service Mode > COPIER > FUNCTION > CLEAR
>FX-L-CLR and clear the Current Value for the Fixing Motor.

NOTE:
• When the Pressure Belt Unit is replaced, perform "Adjustment on replacing the
Pressure Belt Unit" in Situation Mode.
• After replacement of the Fixing Motor, clear "COPIER> FUNCTION> CLEAR>
FX-L-CLR".

E008-0002 / E008-0003: Fixing Belt Unit Life Detection Error

An E008-002 Error will occur when the total rotation time of the Fixing Belt has reached the predetermined
hours for the Fixing Belts life. If a counter clear has not been executed after replacing the Fixing Belt Unit
this error will occur. Make certain to clear the counter and perform "Adjustment on replacing the Fixing
Belt Unit" in Situation Mode when the Fixing Belt Unit is replaced.

E007-0101: Fixing Belt Home Position Detection Error

An E007-0101 Error seldom occurs due to an abnormality of the Fixing Belt Unit however, it can occur due to an
abnormality of the Fixing Belt Displacement Control Motor Unit. If an E007-0101 has occurred, check the
mounting of the Fixing Belt Displacement Control Motor Unit and replace it if needed using the subsequent
procedure.
1) Inspect the mounting of the Fixing Belt Displacement Control Motor Unit and re-mount it properly if
any abnormality is found.
19