Table of Contents
Advertisement
Service Mode > FUNCTION GR.
PCL PaperSource
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PDL Z Logic
SMD-EXPT
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SUBLOG TO USB
Detail
Adj/Set/Operate Method
Caution
USB-H
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
■ ECONF
Service Mode > FUNCTION GR. > ECONF
EXPORT
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
Switching of paper source selection method for PCL use
To switch between the paper source selection methods for PCL use.
Select the item, and then press OK key.
MODE0 to MODE2
MODE0: HP-compatible operation
MODE1: Lexmark-compatible
MODE2: Not in use
MODE0
Not in use
ON/OFF of remote UI service mode saving
To set target data for export on remote UI.
Select the item, and then press OK key.
Set whether to display "service mode" as the target data for export under remote UI > Settings/
Registration > Management Settings > Import/Export > Export.
If installing more than 1 machines at a time, the same service mode data can be registered.
Off/On
Off: Hide "service mode" as target data
On: Display "service mode" as target data
Off
Debug log saving to USB flash drive
To output debug logs to a USB flash drive.
Select the item, and then press OK key.
Available regardless of the USB-H setting.
Cannot execute this twice or more in a row.
Executing this disables the auto recording of debug logs; turn OFF and then ON the main power
after execution.
ON/OFF of USB host function
To enable/disable the USB host function.
Select the item, and then press OK key.
Points to note when removing USB flash drive
- Remove the USB flash drive after turning USB-H to OFF because the USB flash drive is in the
connected state when USB-H is ON.
- Removing the USB flash drive while accessing could cause errors.
Off/On
Off: Not use the USB host function
On: Use the USB host function
Off
Saving of user setting data to USB flash drive
To export device setting data.
Select the item, and then press OK key.
Setting data is exported to a USB flash drive.
GENERAL/DEPEND/SECURITY/ALL
GENERAL: Target the common setting items
DEPEND: Target the machine-dependent items
SECURITY: Target the security-related items
ALL: Target all the items exported by GENERAL, DEPEND and SECURITY
USB-H
220
9. Service Mode
Advertisement
Table of Contents
Troubleshooting
