Supermicro H13SRD-F User Manual page 82

Super H13SRD-F User's Manual
Security Function
Select Password to set an HDD/SATA password, which will allow you to configure the
security settings of the HDD/SATA device. Select Security Erase-Password to enter a
SATA user password to erase the password and the contents previously stored in the HDD/
SATA device. Select Security Erase-Without Password to use the manufacturer default
password "111111111" as the SATA user password and to erase the contents of the HDD/
SATA device by using this default password. The options are Disable and Security Erase-
Without Password.
Note: Security Erase-PSID is only supported by the M.2 TCG function.
Secure Boot

This section displays the contents of the following secure boot features:
•
System Mode
•
Vendor Keys
•
Secure Boot
Secure Boot
Use this feature to enable secure boot. The options are Disabled and Enabled.
Secure Boot Mode
Use this item to configure Secure Boot variables without authentication. The options are
Standard and Custom.
Enter Audit mode

This submenu can only be used if the current System Mode is set to User (refer to Exit
Deployed Mode). The PK variable will be erased on transition to Audit Mode.

Key Management
Provision Factory Defaults
Use this feature to install the factory default secure boot keys after the platform reset and
while the system is in setup mode. The options are Disabled and Enabled.
 Restore Factory Keys
Force System to User Mode. Install factory default Secure Boot key databases.
82