Table of Contents
Advertisement
Terminal Type EMS
Use this feature to select the target terminal emulation type for Console Redirection. Select
VT100 to use the ASCII character set. Select VT100Plus to add color and function key
support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and, ANSI.
Bits Per Second EMS
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 57600, and 115200 (bits per second).
Flow Control EMS
Use this feature to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
The following information is displayed:
• Data Bits EMS
• Parity EMS
• Stop Bits EMS
SATA Configuration
SATA Mode
Use this feature to set the SATA mode. The options are IDE Mode, RAID Mode, and AHCI
Mode.
PCIe/PCI/PnP Configuration
The following information is displayed:
• PCI Bus Driver Version
PCI Devices Common Settings:
Above 4G Decoding (Available when the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and Enabled.
67
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
