Procom MN200EPC Owner's Operation And Installation Manual page 12

OPERATING YOUR HEATER
continued
SETTING TIMER
AUTO ON: With burner off, press
TIMER button. Then press
change to the scheduled time, then
press the TIMER button again, the
TIMER starts timing and the TIMER
will flash. Burner will automatically
come on at the set time.
AUTO OFF: With burner operating,
press TIMER button. Then press
or to change to the scheduled
time, then press the TIMER button
again, the TIMER starts timing and
the TIMER will flash. Burner will
automatically shut off at the desired
time.
LOCKING TOUCH-PAD
(childproof)
A. Key-press locking: Press LOCK
button on the operating panel,
a symbol will appear on the
LCD.
B. Key-press unlocking: Press
then press LOCK button to unlock.
OPERATING BLOWER
Press BLOWER button, for desired
burner operation.
AUTO: Blower will come on several
minutes after burner comes on and
will go off several minutes after
burner goes off.
MAN: Blower operates continuously.
OFF: Blower is off.
TO TURN OFF GAS TO
HEATER
1.Press the IGN/OFF button on the
touch pad.
2.Set the ON/OFF switch to OFF
or to
position on top panel.
Wait one minute to light
NOTE:
again after shutting off heater.
MANUAL OPERATING
INSTRUCTIONS
We provide the manual control sys-
tem just in case of power shortage.
Install battery for Manual Ignitor:
1. Unscrew the ignitor cap.
2. Insert a AAA type battery with its
anode ("+") pointing out.
3. Screw the ignitor back cap.
Note: We recommend that the battery
be taken out of the ignitor when the
power supply gets right.
IF NO ELECTRIC POWER IS
AVAILABLE, HEATER CAN BE OPER-
ATED MANUALLY
1. STOP!
mation on page11 before lighting.
Control Knob
,
2. Check that gas supply to the
heater is on.
3. Remove round access door of
right side panel. Push in control
knob slightly and turn clockwise
to the OFF position.
Read the safety infor-
Ignitor Button
12
If the manual control knob points to
ELECTRIC position, press in the
control knob and turn counter clock-
wise to OFF position.
4. W ait five (5) minutes to clear any
gas. Then smell for gas, includ-
ing near the floor. If you smell
gas, STOP! Follow "B" in the
safety information on page11. If
you do not smell gas, go to the
next step.
5. Push in gas control knob slightly
and turn counterclockwise
PILOT/IGN and depress for five(5)
seconds. NOTE: The first time the
heater is operated after connect-
ing the gas supply, the control
knob should be depressed for
about thirty(30) seconds. This will
allow air to exit the gas system.
6. With control knob pressed, push
and release ignitor button. This
will light the pilot. If needed, keep
pressing ignitor button until pilot
lights.
7. Keep control knob depressed for
ten (10) seconds after lighting
pilot. If pilot goes out, repeat
steps 5,6 and 7.
8. Rotate counterclockwise
ON position to light burner. Do not
operate between locked positions.
to
to