Table of Contents
Advertisement
User Manual
05/18/04
b. To initialize Ethernet port E0, type the following:
ifconfig eth0 -auto
c. To run a program, type the following:
boot -elf tftp_server:/path_to_software/program
Document
91250A-UM100-R
Note: Because the Broadcom PHYs handle direct connects automatically, a crossover cable for
direct connects is not needed.
Note: The ifconfig eth0 -auto command can only be used with a DHCP server.
B roadc om C or por ati on
BCM91250A
Getting Started
Page
5
Advertisement
Table of Contents
Need help?
Do you have a question about the BCM91250A and is the answer not in the manual?