Quectel FC80A User Manual page 47

Wi-Fi&Bluetooth Module Series
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
RSS-210. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre
antenne ou émetteur.
Caution Exposure:
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS102 and
users can obtain Canadian information on RF exposure and compliance.
Le dispositif répond à l'exemption des limites d'évaluation de routine dans la section 2.5 de
RSS102
et les utilisateurs peuvent obtenir des renseignements canadiens sur l'exposition aux RF et le
respect.
This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 centimètres entre le
radiateur et votre corps.
Requirement per KDB996369 D03
2.2 List of applicable FCC rules
List the FCC rules that are applicable to the modular transmitter. These are the rules that
specifically establish the bands of operation, the power, spurious emissions, and operating
fundamental frequencies. DO NOT list compliance to unintentional-radiator rules (Part 15
Subpart B) since that is not a condition of a module grant that is extended to a host manufacturer.
See also Section 2.10 below concerning the need to notify host manufacturers that further
testing is required.3
Explanation: This module meets the requirements of FCC 47 CFR Part15 SubpartC
FCC 47 CFR Part15 SubpartE
2.3 Summarize the specific operational use conditions
Describe use conditions that are applicable to the modular transmitter, including for example any
limits on antennas, etc. For example, if point-to-point antennas are used that require reduction in
power or compensation for cable loss, then this information must be in the instructions. If the
use condition limitations extend to professional users, then instructions must state that this
information also extends to the host manufacturer's instruction manual. In addition, certain
information may also be needed, such as peak gain per frequency band and minimum gain,
specifically for master devices in 5 GHz DFS bands.
FC80A_Hardware_Design 46 / 43