Mechanical Parts; Housing Parts: Housing Shells, Air Filter And Blower Housing Top; Operating Parts: E-Drive Control Button; Metal Parts: Heater Tube, Screws - Leister GHIBLI AW Repair Instructions

Leister Technologies AG

12 Mechanical parts

12.1 Housing parts: Housing shells, air filter and blower housing top

Replace housing shells and/or blower housing top if these parts are fairly worn out (abrasion,
mechanical damage), respectively if the rubber is rough or extremely soaked (sticky)
Replacement of handle requires a replacement nameplate!
Inscribe serial and article number inside the replacement housing shell by using a waterproof
marker; if the nameplate is not readable any more, take production code (yyww) stamped
inside the original housing shell
Replace defective or missing air filters

12.2 Operating parts: e-Drive control button

Replace electronic circuit board HMI (chapter 10.5) if e-Drive control button is fairly worn out
(abrasion, mechanical damage), respectively if the rubber is rough or extremely soaked
(sticky)

12.3 Metal parts: Heater tube, screws

Replace dented heater tube (mechanical stress for mica tube and heating element, nozzles
do not fit any more)
Replace fairly worn out screws (screw heads)

13 Cleaning

Clean the tool when doing service and repair work!
 Air filter  by compressed air, small brush
 Plastic parts (handle and blower housing top)  by ordinary cleaning agent
 Impeller housing  by compressed air (not in direction of motor bearing)
 Heating element  blow off heating channels by compressed air

Note
If clogged air filters were cause of an error, give a message to the customer like as follows:
Clean the air filters at the end of the handle with a small brush if polluted!
Repair instructions
Ghibli AW
Revision: B
QM INN_FO_29
Page 41 / 48
Created 13.04.15 PRI
Released 20.04.15 PRI
Modified 02.07.18 PRI