Motor - Leister GHIBLI AW Repair Instructions

Leister Technologies AG

11.4 Motor


Note
 Tool must successfully pass test procedure after tool assembling (chapter 14)
Repair instructions
Ghibli AW
Revision: B
Open tool according to chapter 8.1
Turn print adapter front up
Extract motor from attachment ring
Loosen motor flex wires from its terminals by
using needle-nosed pliers
Assemble replacement motor
Motor voltage must correspond with rated
voltage of the nameplate
Recessed area for flex wires must face to
the top
Reassemble tool in reverse order; terminate
assembling according to chapter 8.2
Reset timer "Service recommended" in ser-
vice menu (chapter 6.5)
QM INN_FO_29
Page 38 / 48
Created 13.04.15 PRI
Released 20.04.15 PRI
Modified 02.07.18 PRI