Scope Of Applicability; Safety Precautions; Remarks - Leister GHIBLI AW Repair Instructions

Leister Technologies AG

1 Scope of applicability

These repair instructions are reserved exclusively for Leister service centres. Only experi-
enced and qualified personnel trained by Leister Technologies AG, CH-6056 Kaegiswil, are
allowed to do repair work on Leister tools. Additional national requirements relative to per-
sonnel carrying out repair work are to be observed by each service centre.

2 Safety precautions

A well-equipped ESD-protected working place (see chapter 16 " Equipment required for Leis-
ter repair service") is essential for doing qualified work. For safety reasons use only identical
original Leister replacement parts for each type of tool when servicing.
Warning! If you open the tool or remove its parts, except the ones they are accessi-
ble without using a tool, some life parts could appear. Its contact can
cause danger to life! Insure tool is disconnected from the line/mains be-
fore any work is commenced!
Repaired tools must pass the Leister test procedure (see chapter 14
"Test procedure") and any additional local requirements! Check with your
local Statutory Authority for testing requirements.

3 Remarks


If it is impossible to repair a tool, it should be returned immediately to the manufacturer,
Leister Technologies AG, CH-6056 Kaegiswil, Switzerland, carriage paid to Kaegiswil.
Leister will repair the tool within 24 hours after its arrival.

When ordering spare parts use the order numbers of the spare parts list. When servic-
ing use only identical original Leister replacement parts!
Repair instructions
Ghibli AW
Revision: B
QM INN_FO_29
Page 4 / 48
Created 13.04.15 PRI
Released 20.04.15 PRI
Modified 02.07.18 PRI