Assembling And Operation - ALDI WORKZONE TITANIUM HM80MP User Manual

AUS
Before starting the equipment/Assembling and operation
• When working with wood that has been processed before, watch out for foreign
bodies such as nails or screws, etc.
• Before you press the ON/OFF switch check that the saw blade is fitted correctly.
Moving parts must run smoothly.
• Before you connect the equipment to the power supply make sure the data on the
rating plate are identical to the mains data.
VII. Assembling and operation
m Warning! Prior to any adjustment work disconnect the mains power plug!
7.1 Assembling the saw (Fig. 1-6)
• To adjust the turntable (16), push the indexed position lever (12) downwards and
pull the lower locking lever (13) upwards with your index finger.
• Rotate the turntable (16) and pointer (14) to the desired angle on the scale (15)
and lock in place by folding up the the indexed position lever (12).
• Pressing the machine head (5) lightly downwards and removing the fastening
bolt (24) from the motor bracket at the same time disengages the saw from the
lowest position.
• Swing the machine head (5) up until the release lever (3) latches into place.
• It is possible to secure the clamping device (8) to the left or right on the fixed saw
table (17). Long workpieces must be supported by the clamping device!
• Attach the workpiece supports (9) to the fixed saw table (17) as shown in Figure
6a,b,c and push them all the way through. Secure the shafts with the retaining
springs to prevent them from slipping out accidentally. Then fasten them in the
desired position with the screw (10).
• It is possible to tilt the machine head (5) a max. 45° to the left by loosening the
set lever (22).
7.2 Sawdust bag (Fig. 2)
The saw is equipped with a sawdust bag (21) for sawdust and chips.
Squeeze together the metal ring on the dust bag and attach it to the outlet opening
in the motor area.
The sawdust bag (21) can be emptied by means of a zipper at the bottom.
7.3 Using the laser (Fig. 16,17)
• To switch on: Move the ON/OFF switch of the laser (35) to the "I" position. A
laser line is projected onto the material you wish to process, providing an exact
guide for the cut.
• To switch off: Move the ON/OFF switch of the laser (35) to the "0" position.
• Replacing the battery: Switch off the laser (34). Remove the battery compartment
cover (37). Remove the batteries and replace with new batteries (3 x LR44) Check
that the battery terminals are positioned correctly when inserting new batteries.
Close the battery compartment (36) again.
20
 support@scheppach.com.au
MODEL: HM80MP PRODUCT CODE: 53666 06/2019
AFTER SALES SUPPORT

HM80MP
1300 855 831