HM80MP
Check the connection cable of the electric tool regularly and have it replaced
–
by a recognised specialist when damaged.
Check extension cables regularly and replace them when damaged.
–
Keep the handle dry, clean and free of oil and grease.
–
Pull the plug out of the outlet
15
Never remove loose splinters, chips or jammed wood pieces from the running
–
saw blade.
During non-use of the electric tool or prior to maintenance and when replacing
–
tools such as saw blades, bits, milling heads.
When the saw blade is blocked due to abnormal feed force during cutting, turn
–
the machine off and disconnect it from power supply. Remove the work piece
and ensure that the saw blade runs free. Turn the machine on and start new
cutting operation with reduced feed force.
Do not leave a tool key inserted
16
Before switching on, make sure that keys and adjusting tools are removed.
–
Avoid inadvertent starting
17
Make sure that the switch is switched off when plugging the plug into an outlet.
–
Use extension cables for outdoors
18
Only use approved and appropriately identified extension cables for use out-
–
doors.
Only use cable reels in the unrolled state.
–
Remain attentive
19
Pay attention to what you are doing. Remain sensible when working. Do not
–
use the electric tool when you are distracted.
Check the electric tool for potential damage
20
Protective devices and other parts must be carefully inspected to ensure that
–
they are fault-free and function as intended prior to continued use of the elec-
tric tool.
Check whether the moving parts function faultlessly and do not jam or whether
–
parts are damaged. All parts must be correctly mounted and all conditions must
be fulfilled to ensure fault-free operation of the electric tool.
The moving protective hood may not be fixed in the open position.
–
Damaged protective devices and parts must be properly repaired or replaced
–
by a recognised workshop, insofar as nothing different is specified in the op-
erating manual.
Damaged switches must be replaced at a customer service workshop.
–
Do not use any faulty or damaged connection cables.
–
Do not use any electric tool on which the switch cannot be switched on and off.
–
ATTENTION!
21
Exercise elevated caution for double mitre cuts.
–
ATTENTION!
22
The use of other insertion tools and other accessories can entail a risk of injury.
–
AFTER SALES SUPPORT
1300 855 831
MODEL: HM80MP PRODUCT CODE: 53666 06/2019
Safety regulations
support@scheppach.com.au
AUS
15