ALDI WORKZONE TITANIUM HM80MP User Manual page 20

AUS
Assembling and operation
7.11 Precision adjustment for mitre cut 45° (Fig. 1,3,5,19)
• No angle gauge included.
• Lower the machine head (5) and secure using the fastening bolt (24).
• Fix the turntable (16) in the 0° position.
• Loosen the set lever (22) and use the handle (1) to angle the machine head (5)
45° to the left.
• 45° - position angle gauge (b) between the saw blade (7) and turntable (16).
• Slacken the counternut (c). Adjust the adjusting screw (31) until the angle between
the saw blade (7) and turntable (16) is precisely 45°.
• Retighten the counternut (d) to secure this setting.
7.12 Changing the saw blade (Fig. 11-15)
Remove the power plug!
m Caution!
Wear safety gloves when changing the saw blade. Risk of injury!
• Remove the spring (41) from the pin by pushing together the two ends.
• Release the guide bar (40) from the pin.
• Firmly press the saw spindle lock (4), and slowly turn the flange screw (32) clock-
wise. After max. one turn, the saw spindle lock (4) engages.
• Then undo the flange screw (32), by applying a slightly greater force in a clock-
wise direction.
• Fully unscrew the flange screw (32) and remove the outer flange (33).
• Press the release lever (3) to slide back the movable blade guard (6), then remove
the saw blade (7) from the inner flange (39) and pull out in a downwards direction.
Do not use the saw without guards in position and additional safety instruction, if
double bevel-cutting is possible.
• Carefully clean the flange screw (32), outer flange (33) and inner flange (39).
• Insert the new saw blade (7) in the reverse sequence and tighten.
• Position the guide bar (40) on the pin again, and secure with the spring (41).
• Warning! The cutting angle of the teeth, in other words the direction of rotation
of the saw blade (7) must coincide with the direction of the arrow on the housing.
• Before continuing your work make sure that all safety devices are in good work-
ing condition.
• Warning! Every time that you change the saw blade (7), check to see that it spins
freely in the table insert (11) in both perpendicular and 45° angle settings.
• Warning! The work to change and align the saw blade (7) must be carried out
correctly.
24
 support@scheppach.com.au
MODEL: HM80MP PRODUCT CODE: 53666 06/2019
AFTER SALES SUPPORT

HM80MP
1300 855 831