ALDI WORKZONE TITANIUM HM80MP User Manual page 19

HM80MP
7.8 Mitre cut 0°- 45° and turntable 0°- 45° (Fig. 1,2,6,9)
The crosscut saw can be used to make mitre cuts to the left of 0°- 45° in relation
to the work face and, at the same time, 0° - 45° to the left or 0° - 45° to the right in
relation to the fence (double mitre cut).
Caution! To make mitre cuts (inclined saw head), the adjustable fence (28) must
be fixed at the outer position.
• Open the set screw (29) for the adjustable fence (28) and push the adjustable
fence outwards.
• Warning! The adjustable fence (28) must be fixed far enough in front of the in-
nermost position that the distance between the fence (28) and the saw blade (7)
amounts to a maximum of 5 mm.
• Before making a cut, check that the fence (28) and the saw blade (7) cannot col-
lide.
• Secure the set screw (29) again.
• Move the machine head (5) to its upper position.
• Release the turntable (16) by loosening the screw (26).
• Using the Locking lever (13), set the turntable (16) to the desired angle (refer also
to point 7.4 in this regard).
• Re-tighten the screw (26) in order to secure the turntable.
• Undo the set lever (22) and use the handle (1) to tilt the machine head (5) to the
left until it coincides with the required angle value (in this connection see also
section 7.6).
• Re-tighten the set lever (22).
• Cut as described under section 7.5.
7.9 Limiting the cutting depth (Fig. 3)
• The cutting depth can be continuously adjusted using the screw (26). To do this
loosen the knurled nut on the screw (26). Turn the screw (26) in or out to set the
required cutting depth. Then re-tighten the knurled nut on the screw (26).
• Check the setting by completing a test cut. Cutting capacity: See VIII Technical
data
7.10 Precision adjustment for crosscut 90° (Fig. 3,5,18)
• No angle gauge included.
• Lower the machine head (5) and secure using the locking bolt (24).
• Loosen the set lever (22).
• Position the angle gauge (a) between the saw blade (7) and the turntable (16).
• Slacken the counternut (d). Adjust the adjusting screw (30) until the angle between
the saw blade (7) and turntable (16) is 90°.
• Retighten the counternut (d) to secure this setting.
• Subsequently check the position of the angle indicator. If necessary loosen the
pointer (20) using a Philips screwdriver, set to position 0° on the angle scale (19)
and re-tighten the retaining screw.
AFTER SALES SUPPORT
1300 855 831

MODEL: HM80MP PRODUCT CODE: 53666 06/2019
Assembling and operation
 support@scheppach.com.au
AUS
23