ALDI WORKZONE TITANIUM HM80MP User Manual page 18

AUS
Assembling and operation
7.6 Cross cut 90° and turntable 0° - 45° (Fig. 1,6,7)
The crosscut saw can be used to make crosscuts of 0° -45° to the left and 0° -45°
to the right in relation to the fence.
Caution! For bevel cuts (inclined saw head), the moveable fence (28) must be fixed
in the outer position.
• Open the set screw (29) on the moveable fence (28) and push the moveable fence
(28) outwards.
• Warning! The moveable fence (28) must be locked in a position far enough from
the inner position that the distance between the fence (28) and the saw blade (7)
is no more than 5 mm.
• Before making the cut, check that no collision could occur between the fence (28)
and the saw blade (7).
• Tighten the set screw (29) again.
• Use the locking lever (13) to adjust the turntable (16) to the desired angle. The
pointer (14) on the turntable (16) must match the desired angle on the scale (15)
on the fixed saw table (17).
• Tilt the locking lever (13) back up again to fix the turntable (16) in place.
• Cut as described under section 7.5.
7.7 Mitre cut 0°- 45° and turntable 0° (Fig. 1,2,6,8)
The crosscut saw can be used to make mitre cuts of 0° - 45° in relation to the work
face.
Caution! To make mitre cuts (inclined saw head), the adjustable fence (28) must
be fixed at the outer position.
• Open the set screw (29) for the adjustable fence (28) and push the adjustable
fence outwards.
• Warning! The adjustable fence (28) must be fixed far enough in front of the in-
nermost position that the distance between the fence (28) and the saw blade (7)
amounts to a maximum of 5 mm.
• Before making a cut, check that the fence (28) and the saw blade (7) cannot col-
lide.
• Secure the set screw (29) again.
• Move the machine head (5) to the top position.
• Fix the turntable (16) in the 0° position.
• Loosen the set lever (22) and use the handle (1) to angle the machine head (5)
to the left, until the pointer (20) indicates the desired angle measurement on the
scale (19).
• Re-tighten the set lever (22).
• Cut as described in section 7.5.
22
 support@scheppach.com.au
MODEL: HM80MP PRODUCT CODE: 53666 06/2019
AFTER SALES SUPPORT

HM80MP
1300 855 831