ALDI WORKZONE TITANIUM HM80MP User Manual page 14

AUS
Safety regulations
Attention: Laser radiation
Do not stare into the beam
Class 2 laser
Protect yourself and you environment from accidents using suitable precau-
tionary measures!
• Do not look directly into the laser beam with unprotected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting surfaces and persons or animals.
Even a laser beam with a low output can cause damage to the eyes.
• Caution - methods other than those specified here can result in dangerous radi-
ation exposure.
• Never open the laser module. Unexpected exposure to the beam can occur.
• If the mitre saw is not used for an extended period of time, the batteries should
be removed.
• The laser may not be replaced with a different type of laser.
• Repairs of the laser may only be carried out by the laser manufacturer or an au-
thorised representative.
Safety instructions for handling batteries
Do not mix old and new batteries or batteries of different types or manufacturers!
5
Replace an entire set of batteries at the same time.
Immediately remove used batteries from the device and dispose of them prop-
6
erly!
Do not allow batteries to heat up!
7
Do not weld or solder directly on batteries!
8
Do not dismantle batteries!
9
Do not allow batteries to deform!
10
Do not throw batteries into fire!
11
Keep batteries out of the reach of children.
12
Do not allow children to replace batteries without supervision!
13
Do not keep batteries near fire, ovens or other sources of heat. Do not use
14
batteries in direct sunlight or store them in vehicles in hot weather.
18
 support@scheppach.com.au
MODEL: HM80MP PRODUCT CODE: 53666 06/2019
Always make sure that the batteries are inserted with the correct
1
polarity (+ and –), as indicated on the battery.
Do not short-circuit batteries.
2
Do not charge non-rechargeable batteries.
3
Do not overcharge batteries!
4
AFTER SALES SUPPORT

HM80MP
1300 855 831