1200W Circular Saw
Operation
Adjusting the bevel angle
Turn the base plate bevel lock knob (6) anti-clockwise to loosen (Fig. C1), and
tilt the machine away from the base plate (7) (Fig. C2). Set the required bevel
angle by aligning the triangle symbol with the base plate angle scale (3) (Fig.
C3).
Tighten the base plate bevel lock knob (6) by turning it in clockwise
direction.
WARNING! Do not use the depth of cut scale when making bevel
cuts due to possible inaccuracy.
C1
Adjusting the cutting depth
Turn the cutting depth lock knob (15) anti-clockwise to loosen (Fig. D1), and
raise the saw body away from the base plate (7). Set the required cutting
depth by aligning the line symbol (at the rear of the upper fixed guard) with
the cutting depth scale (14) (Take the line mark below the number as the
standard) (Fig. D2). Turn the cutting depth lock knob (15) clockwise to lock
the cutting depth (Fig. D3).
When set correctly, the blade teeth should not protrude further than 3mm
beneath the workpiece.
NOTE: It is best to carry out a trial cut before cutting your workpiece.
13
e-mail: info.aldi@positecgroup.com
MODEL No.: PSC1856.A • 02/2021 • 704518
C2
C3
AFTER SALES SUPPORT
1300 889 028
(toll free)