Fine-Adjusting Focus - Sanyo VCC-HD2500P Manual

PEAK HOLD: Shows the value of the maximum focus level.
INDICATOR: Shows the value of the current focus level.
Fine-adjusting focus (using buttons provided on side face)
1
Use the zoom lever of the lens to adjust the angle of view and the focus lever of the lens to roughly
focus on the subject.
2
Press the SET button.
The camera automatically focuses on the subject. Note that the color of the status indicator (
"FOCUSING" turns from black to orange.
If the camera failes to focus on the subject, the FA bar (
B
( ) showing "ERROR". In this case, manually adjust the focus (in Step
3
Press the NEAR/FAR button to adjust the focus.
Pressing the button causes the back focus position to change, which is indicated in the FB bar gauge (
The position changes step by step each time the button is pressed and continuously at a high speed when
the button is held down.
If you want to restore the default back focus position in re-adjustment, etc., press the NEAR and FAR
buttons simultaneously.
While the camera is initializing the back focus position, the status indicator (
"INITIALIZING".
4
Press the SET button for 2 seconds or more.
The focus adjustment screen will close.
The focus adjustment screen will also close automatically if left idle for 5 minutes or more.
A
) will not operate normally with the status indicator
3
).
B )
C
).
B
) shows
Introduction 15/18