Sanyo VCC-HD2500P Manual page 80

JPEG: VCC-HD2500: 0.1ips, 0.2ips, 0.5ips, 1ips, 3ips, 5ips, 10ips, 15ips, 30ips
VCC-HD2500P: 0.1ips, 0.2ips, 0.5ips, 1ips, 2.5ips, 5ips, 8ips, 12.5ips, 25ips
H.264: VCC-HD2500: 5ips, 10ips, 15ips, 30ips
VCC-HD2500P: 5ips, 8ips, 12.5ips, 25ips
7 In [PRIORITY], select whether you put priority on the video/image quality or the bit rate.
QUALITY, BITRATE
If you selected "QUALITY", in [PICTURE QUALITY], specify the video/image quality.
Then, the system shows an appropriate bit rate depending on the selected quality.
BASIC, NORMAL, ENHANCED, FINE, SUPER FINE
If you selected "BITRATE", in [BITRATE], the system shows an appropriate bit rate for you.
Type the bit rate directly, if you want to change it.
In [STREAM UTILIZATION], the encoder stream utilization rate is automatically shown.
8
The stream utilization rate cannot exceed 100%. Configure stream conditions based on the displayed stream
utilization rate.
Use the encoder stream utilization rate indicated under [STREAM UTILIZATION] only as a guide.
3
Click in the stream list.
SET
The camera will reboot and the settings you configured will be enabled.
You may also choose to change the factory-default stream settings (STREAM1 and STREAM2).
1
Select the check box next to the stream for which you want to change data and click
CHANGE .
The stream registration screen for the selected stream appears in a separate window.
2
Change the desired settings and click
Your changes are saved and reflected in the stream list.
.
SET
Working with Administrator Configuration Screens 17/66