Adjusting The Camera - Sanyo VDC-DP7585P Installation Manual

Adjusting the Camera

bSetting up the camera remotely
Use of the separately ordered Camera Control Unit (VAC-70) is recommended for setting and adjustment of
this camera. Advanced settings are possible from the main menu. For details, see the instruction manual for
the Camera Control Unit.
Video in
Do not forget to disconnect the Camera Control Unit once you have finished setting/adjustment.
Checking the settings screen or camera angle on a portable monitor
(These checks are unnecessary when using the separately
ordered Camera Control Unit (VAC-70).)
Connect the MONITOR OUT pin and the GND pin on the circuit
board to a monitor using an alligator clip cable. Do not forget to
remove the cable after you have finished checking.
A dedicated MONITOR OUT connector is provided for portable
monitors.
b To check the settings screen and make changes
1) Hold down the SET button (1) for over a second.
The main menu appears.
2) Select a menu by pressing the Select button (2) up and
down.
3) Select the setting item and value by pressing the Select
button left and right.
b To check the zoom position and make changes
Press the Select button left and right during live mode
(with no menu displayed).
You can set the zoom (wide: d, tele: c).
bInstallation accessories
1 Hexagonal wrench
(large, small)
VAC-70
VIDEO OUT CAMERA
2 Cushioning sheet
DC IN 3V
Ð +
BNC type
RG-6U coaxial cable
300 m max.
3 Clamping core
7
GND
MONITOR
OUT
SET
UP
LEFT
RIGHT
DOWN
1
2