Table of Contents
Advertisement
Operating
7.2.6 Operating mode 'Preprogrammed automatic show'
Settings for programme 1
Settings for programmes 2 ... 27
Stroboscope
Matrix Blinder 5x5 RGBWW
26
Blinder
This operating mode can only be activated when the device is operating in stand alone mode
or as master in a master / slave combination. This setting is only relevant if the device is not
controlled via DMX.
1.
Press [Mode] repeatedly until the display shows 'Program' .
2.
Press [Setup] repeatedly until the display shows 'Mode' .
3.
Use [Up] and [Down] to select one of the preprogrammed automatic shows 'Mode 1' bis
'Mode 27' .
4.
If you have selected programme 'Mode 1' , press [Setup] repeatedly until the display
shows 'Color' .
5.
Use [Up] and [Down] to select a value between '1' and '39' to set the desired static
colour for programme 1.
6.
If you have selected one of the programmes 'Mode 1' to 'Mode 27' , press [Setup] repeat‐
edly until the display shows 'Speed' .
7.
Use [Up] and [Down] to select a value between '1' (slow) and '100' (fast) to set the run‐
ning speed of the programmes 2 to 27.
8.
Press [Setup] repeatedly until the display shows 'Strobe' .
9.
Use [Up] and [Down] to select a value between '0' (slow) and '99' (fast) to set the flash
frequency of the strobe effect.
Advertisement
Table of Contents
