Operating
7
Operating
7.1 Starting the device
7.2 Main menu
Operating mode 'Automatic'
Stage Quad LED Bundle RGB WW
28
LED Lighting Set
Connect the device to the power supply to start operation. After a few seconds, the display
indicates that a reset is in progress. The device is then ready for use.
Press [Mode] to activate the main menu and select an operating mode. Use [Setup] to select
further options. Use [Up] and [Down] to change the respectively displayed value. When the dis‐
play shows the desired value, press [MODE].
If you do not press any key for about 30 seconds, the display will be blanked. It will be reacti‐
vated to display the previously shown menu by pressing any button.
The set values are retained even when the device is disconnected from the mains power
supply.
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] repeatedly until the display shows 'AUTO' .