Table of Contents
Advertisement
5
Starting up
Connections in DMX mode
DMX indicator
Create all connections while the device is off. Use the shortest possible high-quality cables for
all connections. Take care when running the cables to prevent tripping hazards.
Connect the DMX input of the device to the DMX output of a DMX controller or another DMX
device. Connect the output of the first DMX device to the input of the second one, and so on
to form a daisy chain. Always ensure that the output of the last DMX device in the daisy chain
is terminated with a resistor (110 Ω, ¼ W).
If the unit is properly connected to a turned on DMX controller, the first position of the display
is flashing in DMX mode. If not, the device is not receiving a valid DMX signal.
Starting up
Matrix Blinder 5x5 RGBWW
17
Blinder
Advertisement
Table of Contents
