Table of Contents
Advertisement
Operating
7.2.8 Sound control
Sound mode
Microphone sensitivity
Matrix Blinder 5x5 RGBWW
28
Blinder
This operating mode can only be activated when the device is operating in stand alone mode
or as master in a master / slave combination. This setting is only relevant if the device is not
controlled via DMX.
1.
Press [Mode] repeatedly until the display shows 'Sound' .
2.
Press [Setup] repeatedly until the display shows 'Mode' .
3.
Use [Up] and [Down] to select a value between '1' and '26' to select a sound mode.
4.
Press [Setup] repeatedly until the display shows 'Sensitivity' .
5.
Use [Up] and [Down] to select a value between '0' (low sensitivity) and '31' (high sensi‐
tivity) to set the microphone sensitivity of the selected sound mode.
Advertisement
Table of Contents
