Creative Playthings WILLIAMSBURG PLAY FLOOR SC 908-800Q Assembly Manual

MODEL# SC 908-800Q
ASSEMBLY MANUAL
B
All hardware on this set is specially coated for corrosion
resistance. If non-Creative Playthings hardware is used, it
MUST be galvanized or stainless steel.
Special Notes:
• If also installing a Play Wall, install the Play Floor first. The
Play Wall Slats rest on the Play Floor.
• Sandbox Seats must be removed. They will not be used.
• Install the Play Floor before installing a Picnic Table.
Tools Required:
• 1/2" Socket and Wrench
• Electric Drill with a 3/8" Drill Bit
• Screwdriver or Driver Tip for Electric Drill
Review the original Williamsburg Assembly
Instructions and Owners Manual before assem-
bly for maintenance and safety instructions.
STEP 1 – Drill Holes, Install Stringers:
Drill a 3/8" Diameter hole in the center of the counter-bores
in the Sandbox Sides and Sandbox Ends. Drill two holes
in each of the Sandbox Ends and four holes in each of the
Sandbox Sides.
Fasten the two Platform Stringers (D) between the Sandbox
Ends using two 5/16 x 2-1/2" Lag Screws and Flat Washers
each.
WILLIAMSBURG PLAY FLOOR
19495-300 Rev I (04-20)
WILLIAMSBURG PLAY FLOOR
A
COMPONENTS
A 9 31806-102
B 2 31814-102
C 2 31549-102
D 2 31548-102
E 4 33504-101
G 1 33674-102
Hex Bolt
Lag Screw
Screw
1 50121-710
8 17001-105
8 12017-206
12 12002-206
8 17003-811
4 17003-2211 Hex Bolt 5/16 x 5-1/2"
4 17036-1002 Lag Screw 5/16 x 2-1/2"
78 17020-107
©
Page 1
Copyright 2003, Creative Playthings. Printed in USA.
Platform Board 5/4 x 6 x 56-1/8"
Narrow Plat. Board 5/4 x 4 x 49-3/4"
Cleat 2 x 3 x 52-3/4"
Stringer 2 x 3 x 59-1/2"
Corner Support 2 x 4 x 3-1/4"
Long Narr. Plat. Board 5/4 x 4 x 56-1/8"
Hole Cap
Lock Washer Flat Washer
Hardware, Williamsburg Play Floor
Weld Nut 5/16"
Lock Washer 5/16"
Flat Washer 5/16"
Hex Bolt 5/16 x 2"
Screw #10 x 2"
D
Weld Nut