Commissioning - Beckhoff CP39 Series Manual

Commissioning

4 Commissioning
Operating the control panel
Damage to the touch screen
Operating the touch screen with unsuitable objects may damage the touch screen.
• Operate the touch screen only with bare fingers or wearing suitable gloves.
• If you use gloves, make sure that no hard particles such as metal shavings, glass splinters or similar
adhere to the glove.
If you, as the user, require additional protection for the touch screen against dirt or scratching, for example
due to dirty hands, this can be achieved with a Beckhoff protective film. The film provides short-term
protection for a few days.
You can either order a Beckhoff protective film individually and fit it yourself retrospectively, or you can order
the film for fitting directly ex factory.
Proceed as follows to attach the protective film to the touch screen:
1. For fitting the film choose a location that is as dust-free as possible.
2. Thoroughly clean the surface of the device to be fitted with the film and remove all grease residues.
3. Detach the film from the backing at the short edge and place it on the surface.
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð The film is now fitted.
Commissioning
To use the control panel, you must first put it into operation. The first step is to transport the device to is
operating location and unpack it. This is followed by mounting the device on the mounting arm, connecting
the cables and power supply, and finally switching on the control panel. Since the control panel does not
have its own power switch, switching the power supply on and off also switches the control panel on and off.
26
NOTE
Version: 3.6 CP39xx