Table of Contents
Advertisement
DMX/RDM Gateway
A DMX/RDM gateway, such as an ETC Gateway, can be used to connect a PC to the
DMX/RDM network so that you can configure the fixtures on the network. The Gateway can
be connected directly to a PC with an Ethernet cable. For information about the Gateway,
refer to the appropriate documentation.
Prior to connecting through a gateway, start the RDM configuration tool software and apply
power to the fixtures.
T o C o n n e c t a g a t e w a y t o a P C a n d t h e D M X / R D M n e t w o r k
Step 1:
Step 2:
Step 3:
Figure-2.3 Gateway architecture.
28
Do one of the following.
•
Connect the PC to the local area network via Ethernet and then use an RJ45
cable to connect the gateway to the same network.
•
Using an RJ45 cable, connect the PC to the gateway.
Connect the DMX cable to the gateway.
Connect the other end of the DMX cable to the DMX jack that is connected to the
DMX/RDM network.
Local Area Network (LAN)
RJ45 (Optional)
Computer with Net3 Concert
or UpdaterAtor
RJ45
Gateway
To DMX/RDM device
To DMX/RDM device
To DMX/RDM device
D40XTI Series v1.4.0 User Manual
Advertisement
Table of Contents
