MOTU 828 Mk III Hybrid User Manual page 23

adjust these trims using CueMix FX, see "Input
trim" on page 72. To adjust the trims using the
front panel LCD:
1 Push the CHANNEL knob repeatedly until you
see "I:" (which stands for Input) in the CHANNEL
section of the LCD (Figure 4-7).
2 Turn the CHANNEL KNOB until you see the
desired analog input or input pair. For example,
analog inputs 1-2 appear as "I:An 1-2"
(Figure 4-7), which means Input analog 1-2.
3 From the factory, analog inputs are grouped in
stereo pairs (1-2, 3-4, etc.) If you need to split a pair
to deal with it as two individual mono inputs, turn
the PARAMETER knob until you see PAIR in the
parameter section of the LCD (Figure 4-7). Turn
the VALUE knob to choose MONO. Then turn the
CHANNEL knob again to select the desired input
you are adjusting.
Figure 4-7: The settings for analog inputs 1 and 2 (as a pair).
4 After splitting the stereo pair, if necessary, turn
the PARAM knob until you see the TRIM
parameter in the LCD (Figure 4-8):
Figure 4-6: 828mk3 back panel
I N S T A L L I N G T H E 8 2 8 M K 3 H A R D W A R E
Figure 4-8: Setting the input trim for a TRS analog input pair.
5 Turn the VALUE knob to adjust the trim.
Mic/guitar/instrument sends
Each front-panel XLR/TRS input has a
corresponding send on the rear panel (Figure 4-6).
The output from this send is the pre-amplified and
calibrated signal from the corresponding mic or
guitar input, which you can then route to any other
device, such as compressor, guitar amp, outboard
EQ, reverb unit, etc. Use any 828mk3 input (analog
or digital) as a return back into the 828mk3. From
there, you will be able to route the signal anywhere
in the system, such as to the computer and/or to
any CueMix FX mix bus.
XLR main outs
The XLR main outputs serve as independent
outputs. From the factory, the main out volume is
controlled by the MASTER VOL knob on the front
panel, although this knob can be programmed to
control any combination of outputs. For details, see
"The Monitor Group" on page 88. In a standard
studio configuration, the main outs are intended
for a pair of studio monitors, but they can also be
used as additional outputs for any purpose.
23