Eagle IntelliMap 502C iGPS Installation And Operation Instructions Manual page 110

6. When the necessary search fields are filled in, press ↓ to
| . Your unit asks you to wait while it searches for the ad-
A ENT
DDRESS
dress. (If an address is not in the database, a message appears saying
the address could not be found.)
7. The unit will display a list of addresses. If the address you are look-
ing for is highlighted at the top of the list, press
to select the correct address from the list, then press
Page will then appear with the location selected by the cursor. (In the
following example, we are looking for 12303 East 11th Street in Tulsa,
not 11th Court, so we had to scroll down the list to select the right one.)
Address search result list, left. At center, Map Page showing location
of the address on the map, highlighted by cursor. At right, after the
address is located, you can navigate to it ("D" symbol for destination).
8. To navigate to the address, press
begin showing navigation information to the address pointed out by the
cursor. If you are only looking up an address (not navigating), just
press to return to the previous page.
EXIT
Tip:
If the address also happens to be an item in the Point of Interest
database, you can look up the item's phone number in the Waypoint
Information list. With the address location selected by the cursor on
the map, press
pears, with the Go To Waypoint command highlighted. If you want
to go ahead and navigate to the POI address, just press
. The POI's Waypoint Information window ap-
WPT
|
MENU ENT
104
. If not, use ↓ and ↑
ENT
. The Map
ENT
| and the unit will
EXIT
ENT
F
IND
| .
EXIT