Verathon GlideScope Core Operation & Maintenance Manual page 25

ATTACH THE MONITOR TO THE WORKSTATION
1. Assemble the workstation according to its included instructions.
2. When attaching the quick-release locking plate, ensure the (4) screws are fully tightened and the locking
plate is securely attached to the monitor.
Note: The screws and hex driver are included with the workstation.
3. Slide the locking plate of the monitor onto the quick-release mount. When properly situated, the monitor
sits securely on the mount and the quick-release locking tab locks into the quick-release mount.
4. To remove the monitor, press the locking tab and lift the monitor off the mount.
Operations & Maintenance Manual: Setting Up
2
1
19
0900‑5017 REV‑07